Table of Contents
Advertisement
4 4 . . 3 3 . . 3 3 D D a a i i l l y y F F i i l l t t e e r r
The 2. DAILY option allows operators to perform a daily filter of the oil and a wash
cycle if desired. This filter cycle drains the oil from the vat completely enabling the
user to clean the crumbs out of the vat and wash then down the drain. The crumb
catcher in the drain pan holds the debris and the filter cleans the oil.
The control attempts to detect when the pot does not empty properly. The control
monitors the main temperature probe, and looks for it to begin cooling at a
predetermined rate, as evidence that the oil has drained down below the probe and
24
1 1 . . Select 1. QUICK FILTER. A confirm
prompt displays. If the operator
selects:
•
NO x, the display returns to the previous
menu.
•
√ YES, the drain opens automatically and
the oil begins filtering.
After a few moments, the drain closes and
the oil returns to the vat. When the vat is
close to full, the control panel chirps and a
display timer starts counting down.
If the unit does not detect the oil returning
to the vat and displays IS POT FILLED?,
check the oil level to confirm the vat is full.
If the oil is:
•
Level with the hot fill line on the back of the
vat, press √ YES.
•
Not level with the hot fill line on the back of
the vat, press NO x. The filter pump motor
runs for an additional 30 seconds and
pumps oil from the drain pan.
1 1 . . Select 2. DAILY. A confirm prompt
displays. If the operator selects:
•
NO x, the display returns to the previous
menu.
•
√ YES, the drain opens automatically and
the oil begins draining. As the oil drains a
brush symbol displays. Then three
prompts display: FILL, WASH, DRAIN.
Advertisement
Table of Contents
