Henny Penny KFC Velocity Series Operation Manual page 37

C C h h a a p p t t e e r r 5 5 C C o o o o k k i i n n g g
Start here with a short video explaining the automated startup
T T R R A A I I N N I I N N G G :
sequence.
Watch a short video explaining product programming on the
T T R R A A I I N N I I N N G G :
Velocty control.
Cook menus are your friends. Learn how to set up the fryer to
T T R R A A I I N N I I N N G G :
make the best use of them.
5 5 . . 1 1 D D a a i i l l y y S S t t a a r r t t - - u u p p
If the oil is below 180° F (82° C), with the Main Power switch in the ON position, the
display flashes START UP and AUTO MELT. The oil heats slowly to prevent
scorching of the oil. The heat cycles on and off to slowly heat the oil. When the oil
temperature reaches 215° F (102° C), Auto Melt mode terminates and the fryer begins
heating up to the Auto Mix temperature of 360° F (182° C). During Start-up, the
display informs the user by displaying a bar graph to represent the stages of the start-
up process. These stages consist of the following:
• Melt (Mlt) - Auto Melt mode.
• Mix (Mix) - Automatic filter to ensure oil is mixed to prevent cold pockets.
• Top Off (Top) - Checks to see if oil level is filled to the proper mark. If the unit
senses the oil level is low, it completes an Auto Top Off.
Off Tank in the morning, and top-off throughout the day as necessary.
• Polish (Pol) - The unit completes a polish cycle.
5 5 . . 2 2 H H e e a a t t i i n n g g T T i i m m e e s s
Typical heating times and temperatures are as follows.
Always add oil to the Top
• During each stage, the bar graph fills as
each stage completes.
• The duration of each stage depends on
the temperature of the oil at the initial
start and the programmed setpoints.
• Once start-up is complete, the display
goes to the main cook menu and is
ready for operations.
27