Table of Contents
Advertisement
the probe is now air cooling. If by the end of the initial -Draining- step, the control
has not detected sufficient temperature cooling on the main temperature probe, the
control activates a display that graphically represents a blocked drain, and displays
the messages DRAIN BLOCKED?, CLEAR THE DRAIN. The display continues until
the expected cooling rate is observed on the main probe, or until the operator
presses a button to acknowledge the message.
If the unit does not detect the oil returning to the vat or if the vat sensor detects the
oil is below the full line the message IS POT FILLED? displays. Check the oil level
to confirm the vat is full. If the oil is:
•
Level with the hot fill line on the back of the vat, press √ YES.
•
Not level with the hot fill line on the back of the vat, press NO x and the filter pump motor
runs for an additional 30 seconds.
4 4 . . 3 3 . . 4 4 P P o o l l i i s s h h
The 3. POLISH option extends the usable life of the oil by removing debris through an
extended polishing (filtration) process. An automatic polish to help increase the life of
the oil automatically occurs during the morning startup, after every cook cycle, and
during the daily filter. To manually start a polish, do the following:
Do the following:
2 2 . . Select the WASH option and the wash
cycle begins, WASHING displays.
Once completed, the display returns
to the previous menu. Press STOP
at any time to discontinue wash.
3 3 . . Press FILL to return the filtered oil to
the vat. After a few moments, the
drain closes and the oil returns to
the vat. When the vat is close to full,
the control panel chirps and a
display timer starts counting down.
Press
STOP
at
discontinue fill.
any
time
to
25
Advertisement
Table of Contents
