Henny Penny KFC Velocity Series Operation Manual page 18

2 2 . . 7 7 D D r r a a i i n n P P a a n n A A s s s s e e m m b b l l y y
NOTICE
:
T T R R A A I I N N I I N N G G :
Use these steps after disassembling and cleaning the drain pan, to install a new filter
and reassemble the filtration system and pan assembly.
8
• During assembly be sure to apply oil to all O-rings to
lubricate and to help prevent tears and oil loss.
• Use a small screw driver to gently pry o-rings from their
groove to inspect for damage. Reinstall by gently rolling
them in to place.
• Watch a short video explaining how to lubricate the o-rings
after installation.
Watch how to disassemble and reassemble the Drain Pan.
1 1 . . Slide a filter envelope on to the filter
2 2 . . Fold-over the end of the filter envelope,
3 3 . . Slide a handle clamp on to the other
4 4 . . Place the filter screen in the bottom of
5 5 . . Align the hole in the pickup tube with
6 6 . . Position the pick-up tube so that both
7 7 . . Press down on the pick-up tube to
screen so the plug is protruding
through the hole.
and then slide a handle-clamp over
the end. Ensure the handle faces the
center plug.
ends of the filter screen assembly.
Ensure the handle faces the center
plug.
the drain pan with the plug side up.
the filter screen plug, and then press
down.
sides of the guides slide in to the
holder bracket notches.
confirm it is fully engaged on the
filter screen plug.