Henny Penny KFC Velocity Series Operation Manual page 50

Transport the ODS to an approved oil storage container and empty.
7 7 ) )
Repeat steps 5 through 7, making multiple trips until the vat is empty.
8 8 ) )
6 6 . . 6 6 . . 2 2 . . 3 3 P P u u r r g g e e t t h h e e F F i i t t t t i i n n g g s s
Degraded oil remains inside the lines, valves and fittings. To completely purge the
degraded oil, do the following:
Press the n n e e x x t t ► ► button. The message =PURGE= Pump new oil push old oil
1 1 ) )
from ports displays.
Press the P P U U M M P P button. The pump runs for a few seconds, new oil pumps in to
2 2 ) )
the vat, then the pump stops.
If necessary, press the P P U U M M P P button again to ensure the lines, valves and
3 3 ) )
fittings are purged.
Press the n n e e x x t t ► ► button. The = WIPE = OPEN DRAIN option displays.
4 4 ) )
Press the O O P P E E N N D D R R A A I I N N button. OPENING... displays. Oil drains from the vat.
5 5 ) )
=WIPE= Wipe pot with cloth or paper towel displays.
6 6 . . 6 6 . . 2 2 . . 4 4 W W i i p p e e O O u u t t t t h h e e V V A A T T
To ensure degraded oil does not mix with new oil, do the following:
Use a cloth or paper towel to wipe the remaining oil down the vat drain and
1 1 ) )
clean the vat surface.
Remove the ODS carefully to prevent splashing and spillage, and then close
2 2 ) )
and lock the lid.
Transport the ODS to an approved oil storage container and follow ODS
3 3 ) )
procedures to empty the oil.
When done, store the ODS in a safe location.
4 4 ) )
6 6 . . 6 6 . . 2 2 . . 5 5 F F i i l l l l t t h h e e V V a a t t w w i i t t h h O O i i l l
Fill the vat with new oil by doing the following:
Press the n n e e x x t t ► ► button. EXIT DISPOSE? and YES NO displays.
1 1 ) )
Press Y Y E E S S . - OFF - displays.
2 2 ) )
Clean and dry the drain pan and install a new filter. Refer to
3 3 ) )
Assembly , page 8
Insert the drain pan under the unit.
4 4 ) )
Align and push the quick disconnect filter tube, on the drain pan, in to the filter
5 5 ) )
tube receptacle on the bottom of the unit.
Fill the vat to the lower limit line with fresh oil.
6 6 ) )
Power on the fryer unit and return to normal operation.
7 7 ) )
6 6 . . 6 6 . . 3 3 R R e e a a r r B B u u l l k k O O i i l l D D i i s s p p o o s s a a l l
This section explains the bulk oil process for draining and disposing of oil. Once the oil
has degraded, the vat is drained completely and refilled with new oil. The degraded oil
40
for instructions.
2.7 Drain Pan