Henny Penny KFC Velocity Series Operation Manual page 51

Hide thumbs Also See for KFC Velocity Series:
Table of Contents

Advertisement

is pumped in to a bulk oil storage container using menu commands from the fryer's
control board.
To protect community sewer lines, oil must be trapped and
disposed of through bulk removal. Hot oil can coagulate when
NOTICE
cooled, which clogs pipes and sewer lines. Always dispose of
oil in to an approved bulk oil disposal storage container or
:
approved grease trap. Never pour oil down a public sanitation
drain.
6 6 . . 6 6 . . 3 3 . . 1 1 A A c c c c e e s s s s t t h h e e D D i i s s p p o o s s e e M M e e n n u u
Use the following steps to access the disposal menu. An indicator light displays next
to active options during procedure.
Press and hold the M M a a i i n n menu button until *MAIN* displays. The Main menu
1 1 ) )
displays.
Press the 1 1 . . F F I I L L T T E E R R button. Additional menu items display.
2 2 ) )
Press the M M a a i i n n menu button twice. The dispose menu displays.
3 3 ) )
6 6 . . 6 6 . . 3 3 . . 2 2 D D r r a a i i n n t t h h e e O O i i l l
Drain the oil from the vat by doing the following:
Press the 7 7 . . D D I I S S P P O O S S E E button. The message DRAIN POT? and YES NO
1 1 ) )
displays.
Press the Y Y E E S S button. DRAINING displays.
2 2 ) )
Wait. The oil from the vat drains in to the drain pan. When complete, the
3 3 ) )
message =PURGE= Pump new oil push old oil from ports displays.
6 6 . . 6 6 . . 3 3 . . 3 3 P P u u r r g g e e t t h h e e F F i i t t t t i i n n g g s s
Degraded oil remains inside the lines, valves and fittings. To completely purge the
degraded oil, do the following:
Press the P P U U M M P P button. The pump runs for a few seconds, new oil pumps in to
1 1 ) )
the vat, then the pump stops.
If necessary, press the P P U U M M P P button again to ensure the lines, valves and
2 2 ) )
fittings are purged.
6 6 . . 6 6 . . 3 3 . . 4 4 W W i i p p e e O O u u t t t t h h e e V V a a t t
To ensure degraded oil does not mix with new oil, do the following:
Put on Personal Protective Equipment (PPE).
1 1 ) )
Use a cloth or paper towel to wipe the remaining oil down the vat drain and
2 2 ) )
clean the vat surface.
When done, press the n n e e x x t t ► ► button. A dispose, pump oil to waste tank
3 3 ) )
message displays.
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Oxe-100Velocity seriesVelocity oxe-100

Table of Contents