Mounting; Outside Temperature Sensor Maintenance - Priva Compass Installation Manual

Cable data
Cable type
Maximum cable length
Via Meteorological station interface WI2
Connect the sensor via the Meteorological station interface WI2 to a universal input. See also
Connecting sensors to the Weather interface WI2 (page

Mounting

1. Unscrew the two socket head screws (including clamping rings) on the underside of the Outside
temperature sensor completely.
2. Guide the cable through the appropriate opening in the mast.
The Outside temperature sensor has a set position on the mast.
3. Mount the Outside temperature sensor with the two socket head screws (including clamping
rings) on the support of the mast.
4. Feed the cable through the hole in the clamp block assembly so that the cable re-emerges on
the underside of the block.
Cross-section of the Outside temperature sensor
1. Temperature sensor
The Outside temperature sensor is supplied with a 10-metre shielded cable. It is
recommended that you do not shorten this cable when mounting the unit. Coil the remaining
length of cable or leave a loop; this will simplify any future expansion of the Meteorological
station with additional crossbars of mast sections.

Outside temperature sensor maintenance

Check the Outside temperature sensor regularly for pollution and clean it if necessary. Pollution can
interfere with the performance of the Outside temperature sensor. Clean the unit with a damp cloth
and a little mild detergent if so required.
Installing Priva Compass - 00.014
Outside temperature sensor OTS2
2
4 x 0.8 mm (0.5 mm ) shielded
100 m
58).
2. Printed circuit board (9583)
79