Priva Compass Installation Manual page 57

Position of the wall brackets
1. Mount both wall brackets above each other on the side wall so that the mast is positioned
vertically. See figure
must be at least 60 cm and the brackets must be securely mounted on the side wall.
2. Mount the first two clamping blocks on the top mast component near the socket, placing the
flat side on top. See the left-hand diagram in the figure
Fasten the blocks with the supplied bolts and nuts. Fasten the bolts uniformly.
3. Slide the small support on the mast component and fasten it to the clamp block with four bolts,
nuts and rings. (The small support has room for two sensors.)
4. Mount the other two clamping blocks at the top of the topmost mast component in the same
manner as described under step 2. See the right-hand diagram in the figure
clamping blocks (page
5. Place the large support on the mast component and fasten it to the clamp block with four bolts,
nuts and rings.
6. Mount the Rain sensor and the Linear light sensor or Radiation sensor on the bottommost
support. The Linear light sensor or Radiation sensor must be fitted onto the requisite opening.
Feed the cables of the two sensors through the hole in the clamp block into the mast component
so that the cable re-emerges on the underside of the mast component.
Make sure that the sensors are not damaged during the further installation.
7. Mount the other sensors on the top support and feed the cables through the mast component
downwards.
Pay careful attention to the position of the sensors on the support. Position the sensors
as described in chapter
8. Slide the cap on the underside in both supports until they lock onto the clamp block.
9. Mount the plastic rings in the holes of the caps. These rings prevent the cap from coming loose
when being slid open.
10. Tape together the cables that come out of the underside of the mast component and feed the
cables through the bottom mast component.
11. Tighten the bottom mast component firmly in the socket of the top mast component and secure
the connection by screwing the two socket head screws tightly with the supplied socket head
key.
12. Place the mast in both wall brackets. The base of the mast must protrude at least 10 cm in
relation to the bottom wall bracket.
13. Turn the mast so that the weather sensors are in the position described in the chapter
the sensors (page
Installing Priva Compass - 00.014
Position of the wall brackets (page
56).
Fitting the sensors (page
52).
Meteorological station
55). The distance between the brackets
Mounting the clamping blocks (page
Mounting the
52).
56).
Fitting
55