Connecting The Weather Interface Wi2 To A Universal Input; Extending Cabling - Priva Compass Installation Manual

Priva
Weather interface WI2
9 HIGH 24 VDC
9 LOW GND
10 HIGH WR IN+
10 LOW WR IN-
11 HIGH 24 VDC
11 LOW GND
12 HIGH LL/SOL+
12 LOW GND
13 HIGH GND
13 LOW GND
14 HIGH BT+
14 LOW BT-
15 HIGH RES IN
15 LOW GND
16 HIGH +12 V
16 LOW GND
17 HIGH RG OUT
17 LOW WS OUT
18 HIGH WR OUT
18 LOW LL/SOL OUT
19 HIGH RES OUT
19 LOW GND
20 HIGH BT+
20 LOW BT-

Connecting the Weather interface WI2 to a universal input

1. Connect the interface to a universal input. Use a shielded eight-cored cable, 0.8 mm (0.5 mm²).
2. In the Compass setup, select the correct sensor and, if applicable, the correct sensor type.

Extending cabling

You can extend the cable. Feed the cable from the sensor into a junction box (minimum IP code IP
65) and bridge the distance from the junction box to the Weather interface WI2 with a new shielded
cable.
Never use just tape to extend the cable.
Cable specifications
Cable type
Maximum cable length
60
Sensors or power supply
Wind direction sensor White
Brown
Green
Yellow
Linear light sensor White
LS2WI
Brown
or
Green
Solarimeter CM3P
Yellow
Outside temperature White
sensor
Brown
Green
Yellow
Reserve connection -
(mA)
-
-
-
Output signals to according to
universal input requirements
according to
requirements
according to
requirements
according to
requirements
-
brown
according to
requirements
according to
requirements
4 x 0.8 mm (0.5 mm²), shielded
100 m
24 VDC power supply
Ground
Signal +
Signal -
Do not connect (insulate core)
Do not connect (insulate core)
Signal
Ground
Connect to GND
Connect to GND
Signal +
Signal -
Signal (0–20 mA)
Ground
+12 V power supply (100 mA)
Ground
Output of Rain sensor RD2WI
Output of Wind speed sensor WSS2WI
Output of Wind direction sensor WDS2WI
Output of Linear light sensor LS2WI
Output of reserve connection
Ground for all output signals to universal
input
Outside temperature sensor OTS2 +
Outside temperature sensor OTS2 -
Installing Priva Compass - 00.014