Wind Speed Sensor Wss2Wi; Wind Speed Sensor; Mounting - Priva Compass Installation Manual

Wind speed sensor WSS2WI

Wind speed sensor

The Wind speed sensor generates pulses at a frequency depending on the wind speed. The Wind
speed sensor consists of a rotor with interrupter disc, light source and photo diode.
The Wind speed sensor should preferably be mounted on the Meteorological station and connected
to a Priva process computer.

Mounting

1. Unscrew the two socket head screws (including clamping rings) on the underside of the Wind
speed sensor completely.
2. Guide the cable through the appropriate opening in the mast.
The Wind speed sensor has a set position on the mast and can only be mounted correctly
in one way on the support of the mast.
3. Mount the Wind speed sensor with the two socket head screws (including clamp rings) on the
mounting plate of the mast.
4. Feed the cable through the hole in the clamp block assembly so that the cable re-emerges on
the underside of the block.
Considering that the accuracy of the measurement depends strongly on the environment
(turbulence), you must reconsider the positioning of the Wind speed sensor with every
change in the surroundings (new buildings, tree growth).
Installing Priva Compass - 00.014
Wind speed sensor WSS2WI
75