Maintaining Hardware - Priva Compass Installation Manual

Priva

Maintaining hardware

Replacing the controller battery
• Replace the battery while the controller is on, or the time setting will be lost.
• Priva recommends that the controller battery should be replaced once every five years.
The controller contains one battery. The battery can be replaced while power is connected.
1. Remove the battery holder and battery.
2. Take the old battery out of the battery holder.
3. Install the new battery in the battery holder. Pay attention to the polarity.
The controller will trigger an alarm if no battery has been inserted or if the battery has been
inserted with the incorrect polarity.
4. Install the battery holder and battery in the controller.
5. Dispose of the old battery as chemical waste.
Cleaning hardware
• Avoid contact with live parts.
• Make sure that no water runs into the electrical components.
The following safety precautions apply for cleaning the housing of the hardware:
• Use insulating gloves.
• Remove dust using a soft brush.
• Clean the plastic housing with a slightly damp, soft, lint-free cloth.
• Use warm water only, with a few drops of washing-up liquid if necessary. Do not use solvents
or corrosive or gaseous cleaning agents.
42 Installing Priva Compass - 00.014