Bosch Rexroth IndraDrive CsDrive System with HCS01 Project Planning Manual page 278

276/341 Bosch Rexroth AG
Cables, accessories, additional components
● Length: 5 mm
● Without plastic collar
Length of inner wires incl. ferrules starting at cable jacket: 50 mm
Fold back shield braid over outer cable jacket, comb it out and cut it to
8 mm.
2. Open housing:
● Unscrew housing screw ①.
● Unlock top shell of housing with screwdriver and open housing ②.
3. Connect cable according to interconnection diagram.
4. Insert circuit board into housing in accordance with desired outgoing di‐
rection of encoder cable.
● Put shield braid under clip (A) of strain relief and screw on clip (A).
● Insert mounting screws (B) and tuck wires away.
5. Close housing:
Put top shell of housing onto bottom shell of housing, engage it in bot‐
tom shell and screw housing screw down.
6. Unless already done:
● By means of appropriate crimping tool, add the two contacts for
battery connection.
DOK-INDRV*-HCS01******-PR05-EN-P
Rexroth IndraDrive CsDrive Systems with HCS01