Hiperface® (12 V Supply Voltage) - Bosch Rexroth IndraDrive CsDrive System with HCS01 Project Planning Manual

184/341 Bosch Rexroth AG
Technical data of the components
Connection diagram
Power supply
Cable length
HIPERFACE® (12 V supply voltage)
See the connection diagram for how to connect the encoder system.
1) Line cross section ≥ 0.5 mm²; observe allowed encoder cable
length
2) Line cross section ≥ 0.14 mm²
Fig. 7-3: HIPERFACE® encoder system connection diagram
The HIPERFACE® encoder system needs a supply voltage of 12 V. This
supply voltage is made available via the EC interface.
Technical specification of the power supply: See
on page 195
Please observe that the third-party encoder used has to be suited
for the voltage available at the EC interface as the encoder supply
voltage.
The maximum possible cable length depends on several factors: See
"Encoder cable length" on page 197
DOK-INDRV*-HCS01******-PR05-EN-P
Rexroth IndraDrive CsDrive Systems with HCS01
chapter "12 V power supply"
chapter