Replacement Of Devices - Bosch Rexroth IndraDrive CsDrive System with HCS01 Project Planning Manual

DOK-INDRV*-HCS01******-PR05-EN-P
Rexroth IndraDrive CsDrive Systems with HCS01
Looping through the voltage

Replacement of devices

3.6 V Direct voltage source (battery or UPS)
A Shielded lines, e.g. (2x0,5)C; connect cable shield to
connection
B Twisted single wires
Fig. 8-27: Looping through the voltage
When replacing an HCS01, observe the following aspect:
Leave the 4-pin spring terminal with the connected battery/UPS at the D-Sub
connector so that voltage is still applied and the encoder position is retained.
Bosch Rexroth AG
Cables, accessories, additional components
at top of device
273/341
shield