Operating Time Monitoring; Reaction Monitoring; Interlock - AUMA AUMATIC AC 01.2 Manual

Appendix
No. Type Parameter
24-5 U16 Travel diff. dx (MWG)
24-6 U16 Delay time
Table 51: Operating time monitoring
No. Type Parameter
Offset (hexadecimal) = 0x04C9
Offset (decimal) = 1225
Data length = 4 bytes
25-1 enum Operation mode
25-2 Mmss01 Perm.op. time, manual
Table 52: Reaction monitoring
No. Type Parameter
Offset (hexadecimal) = 0x04CA
Offset (decimal) = 1226
Data length = 4 bytes
26-1 enum Operation mode
26-2 U16 Perm.op. time, manual
Table 53: Interlock
No. Type Parameter
Offset (hexadecimal) = 0x04CB
Offset (decimal) = 1227
Data length = 8 bytes
27-1 enum Oper. mode Interlock
27-2 enum Running dir. Interlock
27-3 enum By-pass Interlock
58
Access Default Setting value
R/W 3 Min = 2
Max = 20
R/W 6000 Min = 1 [0.001 s]
Max = 65535 [0.001 s]
Access Default Setting value
R/W 0 0 : Off
1 : Manual
R/W 9000 Min = 0 [0.1 s]
Max = 36000 [0.1 s]
Access Default Setting value
R/W 0 0 : Off
1 : Manual
R/W 150 Min = 150 [0.1 s]
Max = 3000 [0.1 s]
Access Default Setting value
R/W 3 1 : Remote
2 : Local
3 : Remote and Local
R/W 3 1 : OPEN
2 : CLOSE
3 : OPEN and CLOSE
R/W 0 0 : Off
1 : On
Actuator controls
AC 01.2/ACExC 01.2 Modbus RTU
Explanation
Setting the travel difference dx
The delay time defines the time
interval after terminating manual
operation until reset of the signal
'Handwheel operation'.
Explanation
Operation mode of operating
time monitoring. The actuator
operating time can be made in
'Manual' operation mode.
Perm.op. time, manual
Explanation
Operation mode of operating
time monitoring. The actuator
operating time can be made in
'Manual' operation mode.
Perm.op. time, manual
Explanation
Operation mode of interlock
function
Running direction in which the
interlock function is active
By-pass of interlock function in
operation mode EMERGENCY