Operating Time: Set - AUMA SGM 04.1 Operation Instructions Manual

SGM 04.1 SGM 14.1 / SGMR 04.1
Profinet
10.5.

Operating time: set

SGMR 14.1
Switch steps
SGM/SGMR
04.1
7 55
8 63
9 63
Setting via software parameters (AUMA CDT)
Condition: Switch [S5] is in position ON (software mode).
Setting parameters
Customer settings
Torque switching
Tripping torque CLOSE (S7)
Tripping torque OPEN (S6)
Default value: depending on the order
Setting ranges: adjustable between 40
Operating time is defined by the motor speed.
Setting via switches
Switch [S8] is used to change the motor speed and thus the actuator operating time.
The preset operating time is valid for both operation modes (Local and Remote).
Condition: Switch [S5] is in position OFF (hardware mode).
Figure 24: Switch for operating time
[S8] Operating time
Default value: depending on the order
Setting range: 9 steps (refer to table)
Table 14:
Switch [S8]
Step
SGM/SGMR
04.1/05.1/07.1
1 63
2 45
3 32
4 22
5 16
6 11
7
Commissioning (basic settings of controls)
Tripping torques [Nm]
SGM/SGMR SGM/SGMR SGM/SGMR
05.1 07.1 10.1
110 220 440
125 250 500
125 250 500
100 % of the maximum tripping torque
Operating times for 90° in [s]
SGM/SGMR 10.1
1) 1)
90
1) 1)
63
1) 1)
45
32
22
16
8 11
SGM/SGMR SGM/SGMR
12.1 14.1
900 2,000
1,000 2,200
1,000 2,200
SGM/SGMR 12.1 SGM/SGMR 14.1
275
206
345
150
103 240
75 175
52 120
41 95
31