Christie Mirage SST Installation And Setup Manual page 37

9. Once the projector is in standby, on the projector keypad or the projector remote, press and
hold the power
The projector can also be turned on using the web user interface. After a few seconds, the
projector moves to the on state, causing the yellow light on the laser illumination source to
turn off. The laser is ready to be turned on but no illumination occurs until the green button is
pressed and the lasers have warmed up.
10. On the laser illumination source, press the green Start button (D).
The two Emission status indicators (E) turn red. When the lasers are warmed up and the
projector is ready, you can display an image (use test pattern if no source image is
connected).
On the projector, the Status > Laser Info > Laser Bank State menu displays the message
"Warming Up". When that message disappears, the lasers are ready. It typically takes the
lasers approximately 10 to 15 minutes to warm up when turning on the first time from the off
position. This could be longer if the start-up temperatures are approaching minimum or
Mirage SST Installation and Setup Guide
020-102956-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
button until you hear a beep.
Installation and setup
37