Christie Mirage SST Installation And Setup Manual page 29

5. Make sure the tethered safety cover cannot slide past the stop point.
6. Trim all the cable ties.
7. Slide the tethered safety cover back to the connector end and place the cover over the fiber
connector and its dust cap.
A Fiber connector
B Dust cap
8. Close the safety cover lid using a #2 Philips screwdriver to tighten the captive screw.
Mirage SST Installation and Setup Guide
020-102956-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
29