Turning Off The System; Projector Led Status Indicators - Christie Mirage SST Installation And Setup Manual

Hide thumbs Also See for Mirage SST:

Table of Contents

maximum temperatures for operation. The projector will operate with the shutter closed until

the lasers are warmed up.

Turning off the system

Learn how to turn off all components of the Mirage SST system: projector head, laser and chiller.

When powering off in preparation for inspection or maintenance, always disconnect from AC.

1. To turn the light source off using the projector keypad or remote, press and hold the

until you hear a beep.

The projector can also be turned off with the web user interface. Always allow the projector to

complete the 10 minute cool down cycle before power is turned off at the breaker or

unplugged or projector damage could occur.

2. On the laser illumination source, rotate the main AC lockout/switch (A) to the off position and

rotate the Power key (B) counter clockwise to the off position.

3. Christie recommends, if possible, to keep the chiller operating for 10 minutes after laser AC

lockout/switch A has been rotated to the off position.

For more information on the chiller operation, refer to the chiller's product documentation.

Identify the LED state colors and meaning.

LED

State

Blue

Solid

Flashing

Mirage SST Installation and Setup Guide

020-102956-01 Rev. 1 (06-2019)

Description

Standby

Light source is off. Video electronics are off.

Projector status is OK.

Cool down

Projector is moving to one of the two standby

states:

• Light source is off and video electronics are

booting up.

Installation and setup

button

Table of Contents