Christie Mirage SST Installation And Setup Manual page 31

6. Feed the fiber optic cable with the fiber connector dust cap attached on the tip through the
strain relief.
7. Remove the dust cap from the end of the fiber optic cable and store it in the safety cover.
8. To secure the fiber connector dust cap inside the safety cover, tighten the captive screw.
9. Insert the fiber optic cable into the fiber input ensuring the red dots line up.
10. To lock in place, turn the locking collar clockwise until you see the locking pin start to turn and
no longer moves forward.
11. Attach the strain relief to the projector and tighten the two captive screws to secure it.
12. Wrap the fiber optic cable inside the protective pad and position in the groove.
13. To install the back portion of the clamp over the fiber optic cable and tighten the four screws
removed in step 4.
Mirage SST Installation and Setup Guide
020-102956-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
31