Christie Mirage SST Installation And Setup Manual page 28

Hide thumbs Also See for Mirage SST:

Table of Contents

When attached to the fiber optic cable, make sure the tethered safety cover can be placed over

the fiber connector and the cable tie is sufficiently loose to slide the tether up and down the

fiber cable.

2. Measure a distance approximately 650 mm (25.6 inches) from the end of the fiber connector

down the fiber cable.

3. At this location, create a stop point by placing one cable tie and tightening it.

4. At this same location, place a second cable tie directly beside the first one and tighten it.

To form the stop point, both cable ties should be tightened sufficiently so they cannot slide

down the fiber optic cable.

Mirage SST Installation and Setup Guide

020-102956-01 Rev. 1 (06-2019)

Installation and setup

Table of Contents