Adjusting Boresight - Christie Mirage SST Installation And Setup Manual

Adjusting boresight

The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
1. Close the shutter on the projector.
2. Unlock the three lens mount stabilization screws.
3. Open the shutter.
4. From the Test Pattern menu, select the Boresight test pattern.
The Boresight test pattern assists with adjusting the boresight for the three focus points.
5. To focus the bottom boresight guide, adjust the blue boresight screw.
Adjust the screw 1/4 inch. If you get to the end, further unlock the corresponding stabilization
screw.
Mirage SST Installation and Setup Guide
020-102956-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
44