Setting Up The Ethernet - Christie Mirage SST Installation And Setup Manual

Hide thumbs Also See for Mirage SST:

Table of Contents

5. Select the type network routing appropriate for your projector and select Enter.

Setting up the Ethernet

Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network, modify IP

settings, or manually enter an address.

You cannot change the IP settings using the web interface. Only connect external networks to the

external Ethernet port on the IMXB, not the laser rack RJ45.

1. From the display panel, use the arrow keys to select IP Settings.

2. To set the type of network, select DHCP or Static.

3. If you selected Static, manually enter the network information for the IP Address, Subnet,

and Gateway.

4. Select Apply and select Enter.

5. Select MENU > Communications > Network Settings.

6. Select Device name.

7. Use the up and down keys to enter the name of the projector.

8. Select Enter.

Mirage SST Installation and Setup Guide

020-102956-01 Rev. 1 (06-2019)

Connecting devices and establishing communication

Table of Contents