Christie Mirage SST Installation And Setup Manual page 49

Hide thumbs Also See for Mirage SST:

Table of Contents

2. Loosen the four captive screws securing the optics-side cover and remove it.

3. To adjust the convergence knobs, use the 3 mm tool included with the projector.

If adjusting by hand without using the tool, pull out the convergence adjustment knobs to

engage them.

4. Use the Convergence test pattern to assist with adjusting the horizontal and vertical lines.

Vertical convergence and rotation is done by adjusting two knobs. Christie recommends

rotating a single knob a maximum of a quarter rotation before adjusting the second knob a

quarter rotation. For example, if using one hand, turn the left knob a quarter rotation and then

the right knob a quarter rotation, and so on. Adjusting a single knob for vertical or rotational

adjustment to an extreme before adjusting the second knob may result in the convergence

mechanism binding.

5. When complete, push in all the convergence adjustment knobs to disengage the knobs.

Mirage SST Installation and Setup Guide

020-102956-01 Rev. 1 (06-2019)

G G

Installation and setup

Table of Contents