Changing The Sdsl Rate; Exiting The Command-Line Interface - Lucent Technologies DSLPipe/CellPipe Series Quick Setup Manual

Table of Contents

Advertisement

Changing the SDSL rate

The DSL-HSTB unit ships with the default SDSL rate of 2320 Kbps. You can use any
one of the following rates:
. To change the SDSL line rate, enter the following:
Autohunt option
The DSL-HSTB unit is automatically set to hunt for the line rate. The unit tries
different rates to sync up with the COE site. Depending on the rate set at the COE
side, this might take a few minutes.
To force the DSL-HSTB unit to connect at only a specified speed, you can set the
autohunt option to off. Type the following:

Exiting the command-line interface

To exit the command line interface, type exit at the prompt:
DSLPipe/CellPipe Quick Setup
144 Kbps
272 Kbps
400 Kbps
528 Kbps
784 Kbps
1168 Kbps
1552 Kbps
2320 Kbps
lucent% set sdsl rate <Kbps> (Press the Enter key)
lucent% set autohunt off (Press the Enter key)
lucent% exit
Configuring the unit
DSLPipe/CellPipe Quick Setup
3-17

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DSLPipe/CellPipe Series and is the answer not in the manual?

Questions and answers

Table of Contents