Configuring The Dsl-Hstb Unit; Dsl-Hstb Command-Line Interface; Displaying Status - Lucent Technologies DSLPipe/CellPipe Series Quick Setup Manual

Configuring the DSL-HSTB unit

The DSL-HSTB unit performs bridging over a Frame Relay connection. It supports
symmetrical transmission of 2.3 Mbps. It ships with the DLCI set to 16. If you do not
need to change these default settings, just plug in the cables and you are ready to use
the DSL-HSTB unit

DSL-HSTB command-line interface

After you connect the cables, and set up the communications software (see "Getting
ready to configure the DSLPipe or CellPipe unit" on page 2-1), the following appears
on your VT100 terminal:
Boobase Version: <Version Number> <Date and Time>
RAM Size = 4096 bytes
DRAM POST: Testing: 4096 OK
FLASH: Intel 8M*1
ZYNOS Version: <Version Number> <Date and Time>
Press any key to enter debug mode within 3 seconds...
Version: <Version Number>, start: <hex address>
Length: <hex number>, Checksum: <hex number>
Compressed Length: <hex number>, Checksum: <hex number>
Initialize ch=0, Ethernet address: <MAC addresss>
Start to initialize SDSL...
..................................................
Start to configure SDSL...
SDSL Channel Configuration
Press ENTER to continue...
From the VT100 emulation screen, press the Enter key to see the lucent prompt.

Displaying status

To see the list of all the Frame Relay commands available, type the following:
DSLPipe/CellPipe Quick Setup
The prompt appears.
lucent%
lucent% show fr ?
Configuring the unit
DSLPipe/CellPipe Quick Setup
3-13