Configuring The Dsl-Cell-20A; Dsl-Cell-20A Command-Line Interface; Displaying Status - Lucent Technologies DSLPipe/CellPipe Series Quick Setup Manual

Configuring the unit
DSLPipe/CellPipe Quick Setup

Configuring the DSL-Cell-20A

The DSL-Cell-20A unit performs bridging over ATM with LLC encapsulation. It
ships with a default VPI of 8 and a default VCI of 35. If you do not need to change
these default settings, just plug in the cables and you are ready to use the
DSL-Cell-20A unit.

DSL-Cell-20A command-line interface

After you connect the cables, and set up the communications software (see "Getting
ready to configure the DSLPipe or CellPipe unit" on page 2-1), the following appears
on your VT100 terminal:
Boobase Version: <Version Number> <Date and Time>
RAM Size = 4096 bytes
DRAM POST: Testing: 4096 OK
FLASH: Intel 8M*1
ZYNOS Version: <Version Number> <Date and Time>
Press any key to enter debug mode within 3 seconds...
Version: <Version Number>, start: <hex address>
Length: <hex number>, Checksum: <hex number>
Compressed Length: <hex number>, Checksum: <hex number>
Initialize ch=0, Ethernet address: <MAC addresss>
Loading AADSL modem F/W
..................................................
WAN Channel init...don
Press ENTER to continue...
From the VT100 emulation screen, press the Enter key to see the lucent prompt.

Displaying status

To see the list of all the status commands available, type the following:
3-8
The prompt appears.
lucent%
lucent% show atm ?
e
DSLPipe/CellPipe Quick Setup