Changing The Mux Type; Exiting The Command-Line Interface - Lucent Technologies DSLPipe/CellPipe Series Quick Setup Manual

Configuring the unit
DSLPipe/CellPipe Quick Setup
This changes the VPI or VCI number.

Changing the MUX type

The DSL-Cell-20A ships with the LLC encapsulation as the default. To change the
LLC encapsulation (default) to VC multiplexing, type the following:
To return to LLC, type the following:
In VC multiplexing, the bridged packets will not be encapsulated in the LLC header.
In LLC encapsulation, the LLC header specifies the protocol being transmitted.

Exiting the command-line interface

To exit the command line interface, type exit at the prompt:
3-12
lucent% set atm vpi <number> (Press the Enter key)
or
lucent% set atm vci <number> (
lucent% set atm mux vc (Press the Enter key)
lucent% set atm mux llc (
lucent% exit
Press the Enter key
Press the Enter key
)
DSLPipe/CellPipe Quick Setup
)