Removing Load Box From Trailer - PRONAR T286 Operator's Manual

SECTION 4
In the event of pulling the load box, which is not standing on hard ground, it is permissible to
reverse the trailer after raising the load box to a height enabling it to be pulled in. Soft ground
preventing easy rolling of the load box rollers significantly hinders the pulling process.
Reversing the tractor and pulling the load box should be carried out simultaneousły while
exercising particular caution.

4.5.3 REMOVING LOAD BOX FROM TRAILER

DANGER
When disconnecting the load box from the trailer, the drawbar hitching eye and tractor
hitch are subjected to great loads.
Other persons must NOT be in the immediate vicinity of the trailer and especially behind
the disconnected load box.
Do NOT travel with the trailer if the tipping frame is not completely folded.
Take particular care while working near electric power lines.
Removing load box from trailer must be done on hard, level and flat ground. If not, the load
box rollers may dig into the earth and hinder disconnection from the trailer. The load box
must not be left on a slope.
In order to disconnect the load box from the trailer carry out the following actions in the
following sequence.
Set tractor and trailer on hard level ground; tractor and trailer must be
positioned in order to drive straight forwards.
Fold the rear bumper
Press and hold the push-button for folding
the rear fender. If the fender is completely
folded, indicator light (4) will light up on the
control panel - figure (4.7).
If the fender is not completely folded, the
tipping function does not work.
4.24
Pronar T286