PRONAR T286 Operator's Manual page 97

SECTION 4
Extend the load box interlock.
Press and hold the push-button for extending
the load box interlock.
When indicator light (16) lights up, figure
(4.7) , keep the push-button pressed for 2-3
seconds.
Extend the rear bumper (if the
load box projects more than
400mm).
Press and hold the push-button for extending
the rear fender until the required position of
the rear fender is achieved. Extending is
stopped when the rear fender reaches the
central position. Press the push-button for
extending the rear fender again to continue
extending.
The maximum distance between the rear
fender and the rearmost point of the vehicle
(load box) should not exceed 400mm.
Position of the fender is defined by indicator
lights (4), (5), (6) on the control panel –
figure (4.7).
Place slow-moving vehicle plate on rear wall of load box.
IMPORTANT!
Make sure that the electrical cables will not be damaged by moving parts of the trailer and
the tractor during operation. If necessary, secure the cables in a proper manner.
The central frame in "hook trailer" position can be operated only when the rear fender is
completely folded and the load box lock is unlocked - indicator lights 4, 10 and 15 must be
ON – figure (4.7).
4.23
Pronar T286