PRONAR T286 Operator's Manual page 95

SECTION 4
IMPORTANT!
Selection of the trailer's working mode is only possible when the tipping frame is
retracted to resting position.
If the hook frame is not completely shifted to position B – figure (3.5), the trailer will work
in "tipper" operation mode.
Swing the central frame
Press and hold the push-button for rising the
tipping frame to the position in which the
hook is located at the height of the load box
hitch.
Press and hold the push-button for about 3
seconds to continue rising the frames without
the necessity of depressing the push-button.
Press any push-button on the control panel
to stop rising.
The suspension interlock cylinders will be
automatically extended.
Reverse the trailer to such a position in which the load box can be hooked, If
necessary, correct the hook position according to chapter 4.2.
IMPORTANT!
In "hook trailer" position, after rising the central frame, the hook frame does not shift.
Pulling the load box onto the trailer should be carried out on flat, even and level ground.
While connecting load box arrange it in such a way that the longitudinal axis of the trailer
is aligned with the longitudinal axis of the load box. If not, the load box longitudinal
members of the frame may not fit on the trailer rollers lengthwise. While pulling in the load
box is necessary to observe whether its longitudinal members are properly supported on
the trailer guide rollers. If necessary, stop pulling the load box, put the load box aside and
position the trailer once again in a proper manner for pulling the load box.
4.21
Pronar T286