Table of Contents
Advertisement
Pronar T286
Turn off tractor engine.
Check system components by releasing brake pedal in tractor.
Repeat the system check with depressed tractor brake pedal.
In the event of the appearance of leaks, compressed air will escape at the places of damage,
with a characteristic hiss. Lack of system tightness may be exposed by covering checked
elements with washing fluid or other foaming preparations, which will not react aggressively
with system components. Damaged components should be replaced or repaired. If leaks
appear at connections then tighten the connections. If air continues to escape replace
connection component or seal.
Check system tightness
Visual inspection of the system
During tightness inspection attention should additionally be given to technical condition and
degree of cleanness of the system components. Contact of pneumatic conduit seals etc. with
oil, grease, petrol etc. may cause damage and accelerate the ageing process. Bent,
permanently deformed, cut or worn conduits should be replaced.
Visual inspection of the system
IMPORTANT!
Repair, exchange or regeneration of pneumatic system components may only be
performed in a specialised workshop.
Pay particular attention to conduit connections and brake cylinders.
The help of a second person is required.
• after travelling the first 1,000 km,
• each time after making repairs or changing system components,
• annually.
• Conduct inspection of system at the same time as when checking tightness.
5.20
SECTION 5
Advertisement
Table of Contents
