Table of Contents
Advertisement
SECTION 4
IMPORTANT!
If the trailer is in "tipper" mode (indicator light (9) is ON – figure (4.7)) and the load box
interlock is withdrawn (indicator light (15) is ON - figure (4.7)), the push-buttons for rising
and lowering the tipping frame do not work.
If in the initial phase, the tipping frame can not raise the load box, lower the tipping frame
completely, withdraw the load box interlock, shift the load box to the rear by means of the
hook frame, extend the load box interlock and raise the tipping frame with the load box
again.
Remove remains of load from the load box edges and the trailer components.
Close the rear wall of the load box. If the load box is equipped with the rear
hydraulic wall, use the control panel.
Lower the tipping frame.
Press and hold the push-button for lowering
the tipping frame until the frame is in its
resting position. Press and hold the push-
button for 3 seconds to perform the function
automatically.
After manual folding of the frames, keep the
push-button pressed for 2-3 seconds to
ensure
that
the
cylinders are withdrawn.
If needed, unlock the load box
(if the load box position should
be changed).
Press
and
hold
withdrawing the load box interlock. Indicator
light (15) must light up - figure (4.7). When
indicator light lights up, keep the push-button
pressed for 1-2 seconds.
Press and hold the push-button (17) or (18) - figure (4.7) until the load
box wall is completely opened.
suspension
interlock
the
push-button
for
4.36
Pronar T286
Advertisement
Table of Contents
