Hydraulic System Outlets On The Hook; Electrical System For Controlling The Hydraulic; System - PRONAR T286 Operator's Manual

Pronar T286 SECTION 3

3.2.13 HYDRAULIC SYSTEM OUTLETS ON THE HOOK

The trailer can be equipped with an additional pair of hydraulic outlets located on the hook.
For example, the hydraulic gate of the load box can be connected to the system.
FIGURE 3.20 Hydraulic outlets on the hook
(1) quick coupler-socket, (2) hydraulic conduit
3.2.14 ELECTRICAL SYSTEM FOR CONTROLLING THE HYDRAULIC SYSTEM
The electrical system for controlling the hydraulic system is designed for 12 V DC supply.
The system is supplied using the connection lead with a 3-pin plug at its both ends. The lead
is used for connecting the 3-pin socket (4) on the trailer with the 3-pin electric socket on the
tractor - see chapter 4.3 (HITCHING AND DISCONNECTING THE TRAILER FROM
TRACTOR). If the tractor is not equipped with such a socket or is equipped with a different
type of sockets, carry out the socket installation according to the recommendations of the
tractor manufacturer. The standard equipment of the trailer includes a 3-pin socket for
installing in the tractor.
The trailer's functions are controlled by means of the control panel (1) – figure (3.21). The
control panel is connected to socket (5) using a communication cable. Hydraulic manifold is
controlled by means of actuator module (2). Control signals are collected from inductive
sensors (C1) - (C9) located on the trailer – figure (3.21).
3.28