PRONAR T286 Operator's Manual page 108

SECTION 4
Fold the rear bumper
Press and hold the push-button for folding
the rear fender. If the fender is completely
folded, indicator light (4) will light up on the
control panel - figure (4.7).
If the fender is not completely folded, the
tipping function does not work.
Open the rear wall of the load box and protect it against closing. During
opening, exercise particular caution because the load may exert great
pressure on the wall. If the load box is equipped with the rear hydraulic wall,
use the control panel.
IMPORTANT!
Symbols in the form of arrows (17), (18) - figure (4.7) located on the control panel do not
define rising or lowering direction (it depends on the load box connection method).
If needed, unlock the load box
(if the
should be changed).
Press and hold
withdrawing the load box interlock. Indicator
light (15) must light up - figure (4.7). When
indicator light lights up, keep the push-button
pressed for 1-2 seconds.
Press and hold the push-button (17) or (18) - figure (4.7) until the load
box wall is completely opened.
load box position
the push-button for
4.34
Pronar T286