PRONAR T286 Operator's Manual page 84

SECTION 4
Connect power lead (6) to 3-pin socket (7) on the trailer - figure (4.3) and to 3-
pin socket on the tractor.
Connect communication lead (3) to control panel (1). Install the panel in the
operator cab in an easily accessible place.
Connect the plug of communication lead (3) to control socket (2) located on
the hanger for the trailer conduits.
Release parking brake.
IMPORTANT!
When hitching is completed, secure the electrical leads and hydraulic and braking system
conduits in such a way that they do not become entangled in tractor's moving parts and
are not at the risk of breaking or being severed when making turns.
Unhitching the trailer
In order to unhitch the trailer from the tractor follow these steps.
Immobilise tractor and trailer with parking brake and place chocks under the
trailer wheel.
DANGER
Exercise caution when unhitching the trailer from the tractor. Ensure good visibility.
Unless it is necessary, do not go between tractor and trailer.
Before disconnecting the conduits and drawbar eye, close tractor cab and secure it
against access by unauthorised persons. Turn off tractor engine.
Set the support in such a position that one may safely unlock and unhitch the
trailer.
If the tractor is not equipped with such a socket, an authorized person
should install the socket according to the recommendations of the
tractor manufacturer
Wheel chocks shall be so placed that one of them is in front of the
wheel and the second is behind it.
If the trailer is equipped with the telescopic support with gear, follow
the instructions given in chapter 4.3.1.
4.10
Pronar T286