Hydraulic System; Operating Pto Shaft - PRONAR VMP-5ST Manual

SECTION 2
• Maintain constant auger rotation speed while mixing the feed.
• Do not exceed the maximum rotational speed of drive shaft.
• During manual loading, do NOT stand on a silo or hay stack located above the
mixer feeder tank edge.

2.1.4 HYDRAULIC SYSTEM

• The hydraulic system is under high pressure when the mixer feeder is working.
• Regularly check the technical condition of the hydraulic connections and conduits.
There must not be any leaks of hydraulic oil.
• In the event of the hydraulic system malfunction, discontinue using the mixer
feeder until the malfunction is corrected.
• Before proceeding to maintenance-repair work, make certain that the hydraulic
system is not under pressure.
• Rubber hydraulic conduits must be replaced every 4 years regardless of their
technical condition.
• Use the hydraulic oil recommended by the Manufacturer.
• After changing the hydraulic oil, the used oil should be properly disposed of. Used
oil or oil which has lost its properties should be stored in original containers or
replacement containers resistant to action of hydrocarbons. Replacement
containers must be clearly marked and appropriately stored.
• Do not store hydraulic oil in packaging designed for storing food or foodstuffs.

2.1.5 OPERATING PTO SHAFT.

• The user should thoroughly acquaint himself with the PTO shaft Operator's
Manual and adhere to the recommendations contained in it.
• The machine may only be connected to the tractor by appropriately selected PTO
shaft. Use PTO shaft recommended by the Manufacturer.
• The drive shaft must be equipped with guards. Do NOT use the shaft with
damaged or missing guards. Before starting the machine, always ensure that all
Pronar VMP-5ST | Pronar VMP-6ST
2.5