Installing the expansion card riser assembly
Prerequisite
NOTE:
You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling
and airflow inside the system.
1
Follow the safety guidelines listed in
Steps
1
Place the expansion card assembly into the system board assembly.
2
Align the riser card connector with the connector on the system board, and press the expansion card riser assembly into place.
3
Using the Phillips #2 screwdriver, tighten the screws that secure the expansion card riser assembly.
Figure 47. Installing the expansion card riser assembly
Next step
1
Follow the procedure listed in
Removing an expansion card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the expansion card riser
Steps
1
Remove the screw that secures the expansion card to the assembly.
2
Hold the expansion card by its edges, and carefully remove it from the riser card.
NOTE:
Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
100
Installing and removing enclosure components
Safety
instructions..
After working inside your
enclosure.
Safety
instructions.
Before working inside your
assembly.
enclosure.