EMC VNX Series Hardware Information Manual page 33

3
2
1
7
1 SP B power supply (power in) recessed
connector (plug) from SPS B
2 SP B power supply (power in) recessed
connector (plug) from SPS A
3 SP B (management module) showing two
RJ-45 (management and service laptop)
connectors labeled with a network
management symbol and a wrench
symbol, respectively (for a closer view, see
"Storage processor management module"
on page 34)
4 SP B four-port 8-Gb/s FC I/O module in
slot A2 (for a closer view, see
8-Gb/s FC I/O module" on page
Figure 18 Example of SP components (rear view)
Storage processor AC power supply module
The storage processor (SP) power supply module is located on the left side of each SP
when viewed from the rear (see locations 1 and 2 in
processor (SP) AC power supply module" on page
supply includes three status LEDs (AC, DC, and fault (labeled with an upside-down
exclamation point, !). A latch on the power supply locks it into place to ensure proper
connection.
Do not
remove the SP power supply module while the SP is plugged in. Power supply
module removal for more than a few minutes can cause the SP to shut down due to lack of
cooling.
4
5
5 SP B four-port 6-Gb/s SAS I/O module in
slot B5 (for a closer view, see
6-Gb/s SAS I/O module" on page
6 SP A I/O module filler panel
7 SP A (management module) showing two
RS-232/EIA (micro DB-9) connectors
(labeled with a battery symbol and a
wrench symbol, respectively) (for a closer
view, see
module" on page
"Four-port
48)
Figure
18) of the power supply, each power
EMC VNX8000 Hardware Information Guide
System component description
VNX-000800
6
"Four-port
61)
"Storage processor management
34)
18). On the front ("Storage
33