EMC VNX Series Hardware Information Manual page 21

Control Station front view
Table 4 VNX8000 platform SP and SP chassis (enclosure) status LEDs (continued)
LED
SP unsafe to remove
(see Detail 1 in Figure 6 on
page 17 and exploded view
in Figure 7 on page 19)
Note: One SP will always
have the unsafe to remove
LED on after a successful
shut down.
1. SEP = security processor
On the front, viewing from left to right, the File/Unified VNX8000 platform 1U Control
Station includes the following hardware components:
One DVD-ROM drive
◆
Two USB 2.0 connectors (not used)
◆
Front control panel with various buttons and status LEDs
◆
Four hot-swappable SATA hard drive bays
◆
Figure 8 shows the orientation of these components.
Figure 8 Example of a VNX8000 platform Control Station (front view)
Color State
White On
— Off
DVD-ROM drive
Hard drives
EMC VNX8000 Hardware Information Guide
System component description
Description
The SP peer has a panic or
rebooted with the cache
performance mode enabled. The
SP is holding valid cache in
memory.
The SP is currently flashing the
BIOS/Post firmware or updating
the resume PROMs.
The SP is currently dumping the
cache data to the vault.
The SP can be safely removed for
service.
USB 2.0 connectors Control panel
VNX-000521
21