EMC VNX Series Hardware Information Manual page 15

If your storage system is shipped in a shipping rack (the storage system components
◆
will be removed and put into a customer rack), the factory inserts the battery into the
SPS enclosure in the SPS tray, but does not engage it. The SPS battery is in the parked
position (wheel latch indicator yellow). You must lift the wheel latch up and push the
SPS battery further into the slot of the SPS enclosure to ensure that it is in the
engaged position (wheel latch indicator green).
Air vents
Pull handle
LED indicator
Figure 4 Example of SPS LI-ion battery
Unpacking or removing the SPS battery
To unpack or remove the SPS battery:
IMPORTANT
Attach an antistatic wrist strap to your wrist and connect its cord to a known ground.
1. If shipped separately, unpack the SPS batteries from the shipping containers.
2. Place the batteries separately on an antistatic floor, mat, or workbench pads.
3. If shipped in a shipping rack, remove the SPS batteries from the shipping rack.
4. Place the batteries separately on an antistatic floor, mat, or workbench pads.
Label
Latching features
EMC VNX8000 Hardware Information Guide
System component description
SYM-002673
15