EMC VNX Series Hardware Information Manual page 113

Rear view
On the rear, viewing from left to right, a 4U, 60 (2.5- or 3.5-inch) DAE includes two 6 Gb/s
SAS ICMs (A and B) and two power supply modules (A and B) as shown in
1 2
18
17
16
1 ICM B management (RJ-12) connector (not
used)
2 ICM B USB connector
3 4U, 60 DAE B AC power supply)
4 4U, 60 DAE A AC power supply power in
(recessed plug)
5 ICM A USB connector
6 ICM A management (RJ-12) connector (not
used)
7 4U, 60 DAE B bus ID and enclosure ID
8 ICM A SAS connector (input); labeled with
a double circle (dot) symbol
port is labeled 0 and the bottom port is
labeled 1.
9 ICM A SAS connector (output); labeled
with a double diamond symbol
top port is labeled 0 and the bottom port
is labeled 1
Figure 95 Example of a 4U, 60 DAE with two ICMs and two power supply/cooing modules (rear view)
Note: Between the power supplies and the ICMs on the rear of the 4U, 60 DAE is a
separator bar that indicates the location of the both power supplies and ICMs. Facing rear,
on the right side of the 4U, 60 DAE, is power supply A and ICM A. On the left side of the
40U, 60 DAE is power supply B and ICM B.
3
15 14 13
10 4U, 60 DAE A AC power supply power in
(recessed plug), labeled 1
11 4U, 60 DAE A power and fault LEDs
12 4U, 60 DAE A AC power supply power in
(recessed plug), labeled 0
13 4U, 60 DAE B AC power supply power in
(recessed plug), labeled 1
14 4U, 60 DAE B power and fault LEDs
15 4U, 60 DAE B AC power supply power in
(recessed plug), labeled 0
16 ICM B SAS connector (output); the top port
is labeled 0 and the bottom port is labeled
1.
17 ICM B SAS connector (input); the top port
.
The top is labeled 0 and the bottom port is labeled
1.
18 4U, 60 DAE B bus ID and enclosure ID
.
The
EMC VNX8000 Hardware Information Guide
Disk-array enclosures
Figure
4 5
12 11 10
95.
6
7
8
9
VNX-000627
113