EMC VNX Series Hardware Information Manual page 23

Table 5 Control Station LEDs and push buttons (continued)
LED
Status/fault (see location 5) Green
Reset button
(see location 6)
Onboard (integrated) LAN 1
and 3 (see locations 7 and
8, respectively)
NMI button (see location 9)
ID button with LED
(see location 10)
Color State
On
Blinking
Amber On
Blinking
— Off
— —
Green On
Blinking
— Off
— —
Green On
EMC VNX8000 Hardware Information Guide
System component description
Description
Powered on; status ok
Powered on; degraded.
Redundancy lost, such as power
supply or fan failure, or
predictive power supply failure.
Critical fault: Voltage, thermal, or
power fault; CPU missing;
insufficient power unit
redundancy resource offset
asserted.
Non-critical failure: Critical
temperature/voltage
Power off: System unplugged
Powered on: System powered off
and in standby, no prior
degradation/critical state.
Allows you to reset the CS. Same
as turning the power off and then
on again. Data loss will occur
unless you have saved the data.
The reset button would be used
when a program error occurs and
has caused the CS to freeze.
Pressing the reset button
performs a cold restart (reboot)
which goes through the initial
start-up stages including
memory check.
NIC link/no access
NIC link/LAN access
Idle
Not used
Powered on
23