EMC VNX Series Hardware Information Manual page 17

SPE front view
The front of the VNX8000 platform 4U SPE shows four hard drives with two LEDs per drive
(power and fault), five fan modules with one LED per module (fault), four power supplies
with three LEDs per power supply (AC, DC and DC fault). Four status LEDs per SP: one SP
power on, one SP chassis (enclosure) fault, one SP fault, and one SP unsafe to remove.
3
2
1
1 Latch (orange) for SP B (one per SP);
push down to unlock SP from SPE
chassis
2 Lock latch handle (black) for SP B (one
per SP); after unlocking with the
orange latch (see location 1), pull the
black latch handle horizontally across
the top to release the SP from the SPE
chassis
3 SP B hard drive slot (not used at this
time)
4 SP A power supply
5 SP B power supply recessed
connectors (plugs); two per SP (one
gray and one black)
Figure 6 Example of SP components (front view)
Detail 1
7
8
6 SP A fan module push tabs (push together
to unlock fan), then pull out to release
7 SP A fan module
8 SP A fan fault icon for fault LED (10 places)
Detail SP A status LEDs; SP power on (blue), SP
1 chassis (enclosure) fault (amber), SP fault
(blue/amber), and SP unsafe to remove
(white)
Note: On the inner right side (around the
corner) of the SP, LED labels for the SP and
the SP chassis (enclosure) are shown.
Detail SP A power supply LEDs; AC, DC and fault
2 (labeled with !)
EMC VNX8000 Hardware Information Guide
System component description
SP power on
SP chassis fault
SP fault
SP unsafe to remove
AC
DC
4
!
AC
DC
!
AC
DC
!
AC
DC
!
Detail 2
6 5
VNX-000566
AC
DC
!
17