EMC VNX Series Hardware Information Manual page 31

Table 10 lists the SPS (RJ-12) pin signals used on the connector.
Table 10 SPS (RJ-12) connector pinout
RJ-12 pin Signal name
1 Ground
2 Enabled_out
3 AC_fail_out
4 Any_fault_out
5 SPS_TX
6 SPS_RX
RJ-12 modular jack to micro DB-9 cable
The cable connecting the SPS to the SP management module is an RJ-12 to micro DB-9
cable (plug). It has an RJ-12 connector (SPS side) on one end and a micro DB-9 connector
(SP management module side) on the other end.
SP management module cable.
DB-9
Figure 16 Example of SP management module (micro DB-9) SPS (RJ-12) cable
RJ-12 modular jack to RJ-12 modular jack cable
The cable connecting the SPS to the LCC is an RJ-12 to RJ-12 connector. It has an RJ-12
connector (SPS side) on one end and a RJ-12 connector (LCC side) on the other end.
Figure 17 shows an example of an SPS to LCC cable.
RJ-12
Figure 17 Example of LCC (RJ-12) to SPS (RJ-12) cable
Description
Signal reference
SPS is enabled and ready for On-Battery operation when
needed.
AC line fallen out-of-spec.
Fault state exists within the SPS.
Transmit signal out of SPS to host processor
Receive signal into SPS from host processor
Figure 16
EMC VNX8000 Hardware Information Guide
System component description
shows an example of an SPS to
RJ-12
VNX-000283
RJ-12
VNX-000569
31