EMC VNX Series Hardware Information Manual page 37

Control Station rear view
On the rear, viewing from left to right, the File/Unified VNX8000 platform Control Station
includes the following components:
AC power in connector
◆
Five (RJ-45) connectors (labeled A, CS, B, and two MGMT [one not used, see location 2
◆
in Figure 23])
Note: The RJ-45 connectors (labeled CS and A, respectively) are integrated into the
rear of the 1U Control Station while the RJ-45 connectors (labeled B and MGMT,
respectively) are on a PCI-e card in the expansion slot on the rear of the Control
Station. The fifth RJ-45 connector (labeled MGMT) is located to the left of the RJ-45
connector labeled CS. Newer CS models have a dust cover in this port.
One (DB-9 plug) serial (RS-232/EIA-232) connector
◆
One (DB-9 plug) modem (RS-232/EIA-232) connector
◆
One (DB-15) video (VGA socket) connector—not used
◆
Four USB 2.0 connectors—not used
◆
Figure 23 on page 37 shows the orientation of these components.
1
1 AC power in connector
2 RJ-45 Ethernet port (labeled MGMT), not
used; newer CS models have a dust cap in
this port
3 RJ-45 Ethernet port (labeled CS
Note: The CS label is located below the
USB ports.
4 RJ-45 Ethernet port (labeled A)
Note: The A label is located below the USB
ports.
5 RJ-45 Ethernet port (labeled B)
1. The CS port uses an IPMI (Intelligent Platform Management Interface) cable to connect to a standby (optional)
Control Station (CS1).
Figure 23 Example of a VNX8000 Control Station (rear view)
2 3 4
1 2
MGMT
IOIO
CS A
9 8
10
6 RJ-45 Ethernet port (labeled MGMT)
7 DB-9 serial console plug connector
1
) 8 Four USB 2.0 connectors (not used)
9 DB-15 Video (VGA) socket connector (not
used)
10 DB-9 modem plug connector
EMC VNX8000 Hardware Information Guide
System component description
5 6 7
B MGMT
B MGMT
VNX-000525
37