Product Software And Hardware Release Revisions; Revision History - EMC VNX Series Hardware Information Manual

About this guide
About this guide

Revision history

Product software and hardware release revisions

2 EMC VNX8000 Hardware Information Guide
This guide is designed for personnel who install, configure, and maintain the VNX8000
platform. To use this hardware publication, you should be familiar with digital storage
equipment and cabling.
Only trained and qualified personnel should be allowed to install, replace, or service this
equipment.
The following table presents the revision history of this document:
Revision Date
04 February 25, 2015
03 January 27, 2014
02 October 30, 2013
01 July 23, 2013
As part of an effort to improve its product lines, EMC periodically releases revisions of its
software and hardware. Therefore, some functions described in this document might not
be supported by all versions of the software or hardware currently in use. The product
release notes provide the most up-to-date information on product features.
Contact your EMC representative if a product does not function properly or does not
function as described in this document.
Note: This document was accurate at publication time. New versions of this document
might be released on the EMC online support website. Check the EMC online support
website to ensure that you are using the latest version of this document.
Description
The following sections were updated:
• SP Power supply (page 33)
• Four-port 16 Gb/s optical FC I/O module
(page 51)
• 3U, 120 (2.5-inch) DAE "3U, 120
(2.5-inch) DAE (DAE8S)" on page 94
• Appendix B, Alum-A-Lift
Field lift tool and accessory kit" on
page 168
Miscellaneous edits
•
Miscellaneous edits
The following sections were updated:
• Table 5 on page 22
• "VNX8000 DAE cabling" on page 130
VNX8000 Hardware
First release of the
Information Guide
"Appendix B: