EMC VNX Series Hardware Information Manual page 20

System component description
20 EMC VNX8000 Hardware Information Guide
Table 4 VNX8000 platform SP and SP chassis (enclosure) status LEDs (continued)
LED
SP fault LED, behavior
during normal boot
(see Detail 1 in Figure 6 on
page 17 and exploded view
in Figure 7 on page 19)
SP fault LED, during
degraded boot
(see Detail 1 in Figure 6 on
page 17 and exploded view
in Figure 7 on page 19)
SP fault LED, during faults
(see Detail 1 in Figure 6 on
page 17 and exploded view
in Figure 7 on page 19)
Color State
Amber On (steady)
Blinks once every
4 seconds
Blinks once every
second
Blinks four times
a second
Blue Blinks once every
4 seconds
Blinks once every
second
Blinks four times
a second
— Off
Amber Blinks once every
4 seconds
Blinks once every
second
Blinks four times
a second
Blue Blinks once every
4 seconds
On
— Off
Amber On
Blinks once every
2 seconds
Blinks at 1, 3, 3,
and 1 times a
second
Blue On
Description
SP fault
Executing BIOS
Executing Post
Post starting operating system
Operating system booted
1
SEP driver start in progress
SEP driver start completed
Operating system ready for input
or not powered up
Executing BIOS
Executing Post
Post starting operating system
Operating system booted
Degraded mode
Powered down or no fault
Fault has occurred
NMI reset button pushed;
blinking will continue until SP
reboots and enters power on
sequence.
Memory problem
Fault has occurred