6. Special Binding Method
6-2 To Increase Glue Film Thickness
6-2-1 Spacer Plate Attachment
This section shows how to install spacer plate
on level pate to increase glue film thickness.
WARNING
Do not touch clamper when start but-
ton is depressed. Clamper can cause
severe personal injury.
Necessary Tool : Screw Driver
1.
Pull up stop button.
- LED for stop button on monitor turns off.
2.
Set nipping mode select switch at middle
position to select pad binding mode.
- Pad binding lamp turns on.
3.
Depress milling mode select switch to
select with milling mode.
4.
Confirm lamp on start button turns on.
NOTE
Depress level plate control button when lamp
on start button does not turn on.
Level Plate Button
Start Button
LED for Stop Button
Milling Mode
Select Switch
Far Side
48
Stop Button
Center
Nipping Mode
Select Switch