5. Operation Procedure
5-1 With Cover Binding Operation
This section shows binding operation for with
cover binding.
1.
Pull up stop button.
2.
Depress milling start button.
NOTE
When without milling binding mode is se-
lected, milling start button is not necessary to
depress.
3.
True up stock and insert stock into
clamper. Left side of stock must touch
register shaft in clamper.
NOTE
Left side of stock must be register side. Spine
of stock must face down.
4.
Confirm that lamp on start button is on
and then depress start button.
Stop Button
Clamper
Level Plat Button
Start Button
38
Milling Start Button